Shellab SWPK Manual de usuario Pagina 1

Sheldon Water Purification Kit Installation Guide SWPK SHELDON WATER PURIFICATION KIT

10 | P a g e SWPK INSTALLATION 7) MOUNT THE COVER BOX 1. Locate the slot on the top of the Cover Box. 2. Locate the mounting tab on the top of th

11 | P a g e SWPK INSTALLATION 9) INSTALL A PUSH-TO-CONNECT FITTING The SWPK comes provided with two steel push-to-connect fittings to replace the

12 | P a g e SWPK INSTALLATION 12) CONNECT THE CONDENSATION DRAIN LINE A section of the included ¼ inch OD tubing can be used to connect the cham

2 | P a g e SWPK INSTALLATION Revised: May 8, 2014 Part Number (Guide): 9920698 Sheldon Manufacturing 300 N. 26th Ave Cornelius, OR 97113 E

3 | P a g e SWPK INSTALLATION COMPONENTS The SWPK Assembly comes provided with the following components: Component Part Number* Box Cover 543100

4 | P a g e SWPK INSTALLATION Plumbing Diagram FILTER REPLACEMENT The black Absorber filter is an active charcoal filter. It will last si

5 | P a g e SWPK INSTALLATION INSTALLATION PROCEDURE Complete the steps below (described in detail on the following pages) to install the SWP

6 | P a g e SWPK INSTALLATION 1) INSTALL THE WALTER FILTERS Install the Walter Filters on the SPWK Assembly 1. Insert the top nipple of the light

7 | P a g e SWPK INSTALLATION 2) MOUNTING THE SWPK The SWPK unit can be mounted on your laboratory or workspace wall, or on a Sheldon humidified

8 | P a g e SWPK INSTALLATION 3) CONNECT THE WATER INPUT LINE 1. Connect your water input line to the Regulator on the top of the Purification Ki

9 | P a g e SWPK INSTALLATION 2. A section of the included ¼ inch outside dimension tubing may be used for this step. 3. Do not connect the outpu